Ventilation Systems

Energy Recovery Ventilator	Ventilation Control System
Model 8100	Model 8126
Essentially, the Aprilaire Energy Recovery Ventilator is an efficient, effective way to exchange stale inside air for fresh outside air. In winter months, the exclusive EnergyMax Transfer Core uses the heat of indoor air to warm up the incoming cold fresh air, recovering about 77% of the energy. In summer, warm fresh air passes near outgoing conditioned air, cooling it down. The beauty of the EnergyMax Transfer Core is its use of enthalpic technology. This technology enables the transfer of moisture as well as heat. The popularity of the enthalpic-type ventilator has increased all over the country because of its superior ability to control humidity levels in both winter and summer. The result is greater indoor comfort at the lowest possible cost. Noise is also reduced, since you can enjoy fresh air without leaving windows open. Plus, a fresher, safer home is a home with greater value. While the ideal time to install Aprilaire is during construction, the Energy Recovery Ventilator can be added to any existing heating/cooling system.	If you are a home builder, or are contracting to have your new home built, you should know about Aprilaire's new solution for ventilation. Our Ventilation Control System allows you to manage the quality of air, moderating the extremes of temperature and humidity allowed by other approaches. It will not ventilate if the outdoor temperature is above 100 degrees, below 20 degrees or if the relative humidity could rise above 55 percent. Plus, the system will ventilate only with a heat call when the outdoor temperature is between 0 and 20 degrees. Controls are automatic and independent, with cycle times ranging from one to four hours and ventilation time from zero to sixty minutes. Aprilaire’s Ventilation Control System is a great product for today’s homes. Ventilation is code in a growing number of areas and it helps protect the homes you build.
Specs:	System Includes:
* Dimensions: 37 3/8" wide x 20 9/16" high x 12 3/4" deep * Unit Capacity: Handles up to a 3,600 square foot home * Free Air Flow: 150 CFM each air stream * Design Air Flow: 120 CFM @ 0.3" w.g. external duct resistance, i.e., 240 equivalent feet for each of the "fresh" and "stale" air streams * Electrical Usage: 120 VAC, 60 HZ, 1.4 AMPS * Apparent Sensible Effectiveness @ 120 CFM: 77% (temperature efficiency) * Connecting Ducts: 6" diameter, no special adapters required * Access Door: Door opens to provide access to filters, EnergyMax (tm) Transfer Core, and blowers * Insulation: 1" foil-covered fiberglass ductboard (R=4.25) * EnergyMax (tm) Transfer Core: Cross-flow treated media and aluminum * No Condensate Drain or Defrost Cycle Needed: The exhaust air stream is partially dehumidified so that the exhaust air seldom reaches the dew point * Filters: Two 10 13/16" x 11 5/16" x 3/32" EZ Kleen Air Filters for both exhaust and fresh air streams * Unit Warranty: Three-year limited warranty against defects in materials and workmanship * Core Warranty: Five-year limited warranty against defects in materials and workmanship * Weight: 76 pounds	* Controller * Damper * Transformer Controller Specifications: * Input (R, C): 18 to 30 VAC, 1 amp max * Damper Output: 18 to 30 VAC, 1 amp max. closed contact * Temperature Accuracy: + or - 5 degrees F * Cycle Time: 1, 2, 3 or 4 hours (selectable) * Ventilation Time: 0 to 60 minutes Damper Specifications: * Normally closed, power open * 24 VAC * 0.41 amp * 2 wire * 6" diameter * 10 3/4" long * Max Static Pressure: 1.0" WC
Only $850.00	Only $225.00
Click Here To Order!	Click Here To Order!